Installation Guides

Essential Kit 30 minutes

1

Mount the sensor hub

Secure the sensor hub in the habitation area using the included mounting bracket. Choose a central, well-ventilated location.
2

Connect the MQ-2 gas sensor

Position the gas sensor near the cooker or heater. Mount at low level for LPG detection. Connect to the sensor hub via the provided cable.
3

Position DHT22 sensors

Place one DHT22 sensor inside the habitation area and one outside (under an awning or protected spot). Avoid direct sunlight.
4

Install water level probes

Attach the water level probes to your fresh and grey water tanks using the adhesive-backed sensors. Route cables to the sensor hub.
5

Connect the BMP280 barometric pressure sensor

Plug the BMP280 module into the I2C port on the sensor hub. This provides atmospheric pressure and weather trend data.
6

Wire to 12V power

Connect the 12V-USB-C converter to your leisure battery circuit. Route the USB-C cable to the sensor hub.
7

Insert MicroSD card and power on

Insert the included MicroSD card for local data logging. Power on the sensor hub and wait for the status LED to turn solid green.

Pro Kit 60 minutes

1

Complete Essential installation first

Follow all 7 steps of the Essential Kit installation above before proceeding.
2

Plug in vLinker MC+ OBD adapter

Locate the OBD-II port under the dashboard on the driver side. Plug in the vLinker MC+ adapter firmly until it clicks.
3

Attach TPMS valve cap sensors

Replace the existing valve caps on all 4 tyres with the Roverzo TPMS valve cap sensors. Hand-tighten only.
4

Mount ultrasonic LPG sensor

Attach the ultrasonic sensor to the top of your gas bottle to monitor LPG level without cutting any pipes.
5

Open Roverzo app and pair via Bluetooth

Launch the Roverzo app on your tablet. Go to Settings and tap "Pair Devices". The app will discover all connected sensors.
6

Run initial scan

With the engine running, tap "Full Scan" in the app. Verify that 30+ parameters are being read correctly.

Ultimate Kit 90 minutes

1

Complete Pro installation first

Follow all steps of the Pro Kit installation above before proceeding with security components.
2

Mount ADXL345 accelerometer

Attach the accelerometer to a flat, rigid surface (e.g. floor or chassis rail) using the included adhesive pad. Ensure it is level.
3

Position PIR motion sensor

Mount the PIR sensor in a central interior location with a clear line of sight to the main habitation area.
4

Install reed switch sensors

Attach 4 reed switch sensors to doors and windows. Mount the magnet on the moving part and the sensor on the frame.
5

Mount 120dB siren

Install the siren in a hidden but acoustically effective location. Wire to the sensor hub alarm output.
6

Wire immobiliser relay

Connect the immobiliser relay to the starter circuit. This prevents engine start when the security system is armed. Follow the wiring diagram in the printed guide.
7

Mount GPS module

Position the GPS module where it has a clear view of the sky (e.g. near a window or under a thin roof panel).
8

Connect LiPo battery backup

Plug the LiPo battery into the sensor hub backup port. This ensures the security system remains active if main power is cut.
9

Mount SOS button

Install the SOS button in an accessible location (e.g. near the driver seat or habitation door). Connect to the sensor hub.
10

Configure security zones in app

Open the Roverzo app, go to Security settings, and assign each sensor to a zone. Test the alarm by triggering each sensor.